Installation
ATCA-7360 Installation and Use (6806800J07S
)
48
During the safety qualification of this blade, the following on-board locations were identified
as critical with regards to the maximum temperature during blade operation. To guarantee
proper blade operation and to ensure safety, you have to make sure that the temperatures at
the locations specified in the following are not exceeded. If not stated otherwise, the
temperatures should be measured by placing a sensor exactly at the given locations.
Table 2-2 Critical Temperature Limits
Component
Thermal Design
Power
Max Case or Junction
Temperature
Nehalem-EP
60 W
T
jmax
=100°C (junction)
Tylersburg IOH36 D
27.1 W
T
cmax
=105°C (case)
ICH10R
4.5 W
T
cmax
=105°C
Intel 82599 (Niantic)
8.82 W
T
cmax
=120°C
Intel 82576 (Kawela)
2.8 W
T
cmax
=110°C (case)
Intel 82572EI
2.1 W (typ. 1.5W)
T
cmax
=97°C (case)
Payload DCDC 48 V/12 V
10 W
DDR3 DIMM Modules
6.9 W (estimate TS
team)
85° C
CPU VCC controller (up to
100 A)
6 W
Summary of Contents for ATCA-7360
