BIOS
ATCA-7360 Installation and Use (6806800J07S
)
94
4.4.4
iSCSI Setup for Base and Fabric Ethernet
The board supports boot from iSCSI block devices connected to Base or Fabric Ethernet. To
enable the iSCSI boot, proceed as follows:
1. From the menu, select Boot.
2. Under the Option ROM Execution sub menu, select the iSCSI item of Fabric Network Boot
setup option.
3. Save and Exit the BIOS setup.
4. To enter iSCSI setup, press Ctrl-D when following message displayed:
Intel (R) iSCSI Remote Boot version 2.7.53 Copyright (c) 2003-2010 Intel Corporation. All rights
reserved. Press ESC key to skip iSCSI boot initialization. Press <Ctrl-D> to run setup...
Figure 4-3
Option ROM Execution
Summary of Contents for ATCA-7360
