ARTEX PRODUCTS / ACR ELECTRONICS, INC
DESCRIPTION, OPERATION, INSTALLATION AND MAINTENANCE MANUAL
ELT 345 (P/N: A3-06-2880)
Page 10 of 58
25-62-35
INTRODUCTION
TASK 25-62-35-990-801
1.
Manual Usage
SUBTASK 25-62-35-990-001
A.
General
1)
This manual describes the operation, installation and maintenance of the ARTEX ELT 345 emergency locator
transmitter (ELT). The information is provided to ensure initial and continued airworthiness. Information
presented in this manual is accurate at the time of printing, but is subject to change. Refer to the ARTEX web
site at
for the latest information and any updates to this manual.
2)
Information on the COSPAS-SARSAT emergency locator beacon registration requirements and procedures is
provided in Appendix A – ELT Registration on page 57.
3)
ACR Electronics reserves the right to add approved components to the ELT system; including but not limited to
antennas, remote switches and coaxial cables. These changes are approved as “minor changes” pursuant to
FAR 21, Subpart O for TSO holders.
4)
Regulatory references contained herein are generally confined to Web links provided in this manual and were
accurate at time of printing, but may be subject to change. Consult your national aviation authority for
applicable requirements.
SUBTASK 25-62-35-990-002
B.
Application
1)
This manual constitutes supporting data/documentation for the ARTEX ELT 345, including:
a)
Description and Operation
b)
Test and Fault Isolation (includes inspection criteria)
c)
Removal
d)
Installation
e)
Registration
f)
Illustrated Parts List
2)
In the United States, the ARTEX ELT 345 must be installed and maintained in accordance with the requirements
herein, 14 CFR, FAR Parts 43, -91 and other airworthiness requirements, as applicable.
3)
In Canada, the ARTEX ELT 345 must be installed and maintained in accordance with the requirements herein
as well as Canadian Aviation Regulations (CAR); Part V, Paragraph 551.104 as well as other CAR airworthiness
requirements, as applicable.
4)
ARTEX ELT 345 installation and maintenance in all other countries must comply with the requirements herein
as well as applicable national airworthiness requirements.
5)
The accessories (i.e. remote switch and antennas) referenced in this manual are those most commonly
associated with the ARTEX ELT 345. Other options, such as an alternative remote switch configuration or a
navigation interface, should be installed and maintained in accordance with instructions specific to the
accessory.
NOTE: Contact ACR Electronics, Inc. for optional accessories approved for use with the ARTEX ELT 345.
6)
To ensure proper operation, only parts listed in the Illustrated Parts List of this manual or those recommended
by ACR Electronics, Inc. may be used as replacement parts for the ARTEX ELT 345.
