ARTEX PRODUCTS / ACR ELECTRONICS, INC
DESCRIPTION, OPERATION, INSTALLATION AND MAINTENANCE MANUAL
ELT 345 (P/N: A3-06-2880)
Page 52 of 58
25-62-35
8)
Replace the four screws. Apply a 5 in-lb. torque on the screws. Tighten as below before torque is applied in the
same way.
9)
Affix the supplied expiration date label in the place of the expired one.
10)
Reinstall the ELT in its mount, secure it and connect the antenna leads and remote control wire harness.
11)
Place the manual switch in the “ON” position and monitor the ELT’s operation with a communication receiver
tuned to 121.5 MHz. If the ELT can be heard, move the switch back to the “OFF” or “ARMED” position. Verify
that there is no 7-flash error code displayed on the status LED; see applicable ELT Manual for details on
testing ELT.
12)
Enter in the airframe logbook the date of the installation of the new battery pack and the next replacement
date. The sticker enclosed with battery pack can be used for this purpose.
13)
Do not discard the old battery pack in fire or flame. Dispose of the battery pack as per local environmental
regulations.