7
Doc.-no.:
DS85P_01_EN
issue:
09/2018
3.1 Dimension
All specifications in mm.
3.2 Wall mounting
1. Hold the DS85P against the wall, mark the mounting holes.
2. Drill fixing holes for sufficiently dimensioned screws or dowels.
3. Press in the dowels.
4. Insert the fixing screws through the screw channels of the housing screws so that
the screws protrude from the rear of the housing.
5. Place the housing with the screws exactly on the fixing holes with the dowels.
6. Tighten the screws.
4. Start-up
4.1 Pressure connections
Connect all pressure connections properly with plastic hoses (inner diameter 5mm).
4.2 Electrical connection
The differential pressure sensors are electrically connected via a three wire 50 cm long
colour-coded cable.
