19
AHLINK
If the device does not appear
on the window, the AHlink signal
is not active. To activate, press
for 2 seconds the Up/Down
button located on cover plate,
or contact close to GND GPI
pin2 during 2 seconds. You will
hear 5 beeps indicating that the
AHlink signal is activated.
The AHlink name always begins
with AH characters and the
fourth last MAC AHlink address.
Select the device to control and
set up the unit.
When selecting the device, the
first page will upload. This page
is used to check the device
and for basic installation set up.
Summary of Contents for AHDTL
Page 2: ......
