10
OPTION 1
- Double-side
tape or glue used can’t be thicker than 0,2
-0,25mm [0.008-0.01]
2. Clean the top surface of the metal monitor housing and the
bottom surface of the Veneer.
3. Glue the Veneer. Double-side tape or glue can be used
(depending on the kind of materials are going to be jointed).
1. Check if the Veneer fits perfectly with the monitor. To join both parts correctly it is important that the two surfaces
are touching each other in the whole length. (To make easier the adjustment the hight of the touch button can be
barely adjusted.)
The pressure applied
must not exceed 1 Kg
evenly distributed on
monitor surface.
Veneer Guide (Optional)
