10
MOUNTING INSTRUCTIONS
Introduction
The DynamicCableRetract device is prepared to
be mounted from below the table.
A cover plate is supplied if the hole on the table
can’t be made properly or if aesthetically is
required.
Included in all versions are all necessary brackets
for the installation.
Attention
Manipulation of the product should be avoided; no stress should be applied
to the product except from the instructions given in this document. Cutting,
drilling, soldering, adding of electrical and mechanical components can
cause danger and should be avoided by all mean. Not complying with
these direction will result in a loss of the Arthur Holm warranty.
Albiral Display Solution S.L. shall not be held liable for any loss or injury
incurred as a result of modifications made to goods by anyone other than
the supplier or the supplier's authorised representative without the supplier's
written permission. Such modifications shall be deemed to terminate any
further guarantee obligations. Compensation will not be paid for wages,
loss of profit, waste of time, packing and transport or any financial liability
resulting from defects in the goods. (Albiral Display Solutions shall not be
liable for any loss or injury caused by negligence.)