ARTHUR MARTIN AC3200AOW2, User Manual

Problem

Possible cause

Solution

The valve is blocked.

Check the valve.

The lamp does not work.

The lamp is defective.

Refer to "Replacing the

lamp".

The compressor operates

continually.

Temperature is set incor‐

rectly.

Refer to "Operation" chap‐

ter.

Large quantities of food to

be frozen were put in at the

same time.

Wait some hours and then

check the temperature

again.

The room temperature is too

high.

Refer to climate class chart

on the rating plate.

Food placed in the appli‐

ance was too warm.

Allow food to cool to room

temperature before storing.

The lid is not closed proper‐

ly.

Check if the lid closes well

and the gaskets are undam‐

aged and clean.

There is too much frost and

ice.

The lid is not closed correct‐

ly or the gasket is deformed/

dirty.

Refer to "Opening and clos‐

ing the lid".

The water drainage plug is

not correctly positioned.

Position the water drainage

plug in the correct way.

Temperature is set incor‐

rectly.

Refer to "Operation" chap‐

ter.

The temperature in the ap‐

pliance is too low/too high.

The temperature regulator is

not set correctly.

Set a higher/lower tempera‐

ture.

The lid is not closed correct‐

ly.

Refer to "Opening and clos‐

ing the lid".

The products' temperature is

too high.

Let the product temperature

decrease to room tempera‐

ture before storage.

Many products are stored at

the same time.

Store less products at the

same time.

The thickness of the frost is

greater than 4-5 mm.

Defrost the appliance.

The lid has been opened of‐

ten.

Open the lid only if necessa‐

ry.

Products to be frozen are

placed too closely to each

other.

Make sure that there is cold

air circulation in the appli‐

ance.

10