ARTHUR MARTIN AFB9571MX, User Manual

10

CONTROLS

The hood is fitted with a control panel with 

aspiration speed selection control and a 

light switch to control cooking area lights.

Use the high suction speed in cases 

of concentrated kitchen vapours.  It is 

recommended that the cooker hood 

suction is switched on for 5 minutes prior 

to cooking and to leave in operation 

during cooking and for another 15 minutes 

approximately after terminating cooking. 

The control switches are located on the 

unit’s front panel:

1   Motor ON/OFF button

  By pressing the button, the hood starts 

at speed 1.

  Pressing the button (OFF) while the 

hood is in function turns the latter off.

2   Speed increase button

  By pressing the button, the hood starts 

at speed 1.

  Pressing the button (while the hood is 

on) modifies the motor speed:

Speed 1: 

the number “

1

” appears on 

the display

Speed 2: 

the number “

2

” appears on 

the display

Speed 3: 

the number “

3

” appears on 

the display

High-speed: 

the number “

4

” appears 

(flashing) on the display

  The high-speed function is regulated 

by a timer. The standard time setting is 

5’, at the end of which the hood adjusts 

to speed 

2

.

  Press button  

2

  to deactivate this 

function before the set time expires; 

the hood will adjust to speed 1. Press 

button  1  to turn the hood off.

3   Lights ON/OFF button

4   Speed timer button

5   Display

Speed timer button

Press button  

4

  to activate the speed 

timer; the hood turns off once the set time 

expires.

The timer functions in the following way:

• 

Speed 1

 - 20 minutes (the number “

1

” 

and a small flashing LED light appear 

on the display)

• 

Speed 2

 - 15 minutes (the number “

2

” 

and a small flashing LED light appear 

on the display)

• 

Speed 3

 - 10 minutes (the number “

3

” 

and a small flashing LED light appear 

on the display)

• 

High-speed

 - 5 minutes (the number 

“

4

” and a small flashing LED light 

appear on the display)

Press button  

1

  or button  

4

  to turn 

the hood off while the speed timer is in 

function; by pressing button  

2

 , the hood 

returns to the set speed.

Saturation indicator of the grea-

se filter 

After 80 hours of operation, the display 

shows alternately the set speed and the 

letter “

F

”.

Saturation indicator of the char-

coal filter

After 320 hours of operation, the display 

shows alternately the set speed and the 

letter “

C

”.

Reset of saturation indicator

In order to reset the saturation indicator, 

switch on the hood then press and hold 

button  

1

  for about 3 seconds.

Perform filter maintenance as 

recommended in this manual.

In the event that both indicators of filter 

saturation “

F

” and “

C

” start flashing, 

proceed with the reset twice.

The saturation indicator of the charcoal 

filter is not normally active and if the hood 

is used in the recirculation mode, it must 

be activated manually the first time.