ARTHUR MARTIN AGS6435X, User Manual

Gas Connection

WARNING! The following

instructions about installation,

connection and maintenance

must be carried out by qualified

personnel in compliance with

standards and local regulations

in force.

Choose fixed connections or use a flexible

pipe in stainless steel in compliance with

the regulation in force. If you use flexible

metallic pipes, be careful they do not

come in touch with mobile parts or they

are not squeezed. Also be careful when

the hob is put together with an oven.

Make sure that the gas supply

pressure of the appliance

obeys the recommended

values. The adjustable

connection is fixed to the

comprehensive ramp by means

of a threaded nut G 1/2". Screw

the parts without force, adjust

the connection in the

necessary direction and tighten

everything.

A

B

C

A. End of shaft with nut

B. Washer supplied with the appliance

C. Elbow supplied with the appliance

WARNING! It is important to

install the elbow correctly.

Make sure that the shoulder is

on the end of the thread. Then

install it on the hob connecting

pipe. Incorrect assembly may

cause a gas leakage.

Liquid gas

Use the rubber pipe holder for liquid gas.

Always engage the gasket. Then continue

with the gas connection.
The flexible pipe is prepared for apply

when:
• it can not get hot more than room

temperature, higher than 30°C;

• it is no longer than 1500 mm;

• it shows no throttles;

• it is not subject to traction or torsion;

• it does not get in touch with cutting

edges or corners;

• it can be easily examined in order to

make sure its condition.

The control of preservation of the flexible

pipe consists in checking that:
• it does not show cracks, cuts, marks of

burnings on the two ends and on its full

length;

• the material is not hardened, but shows

its correct elasticity;

• the fastening clamps are not rusted;

• expired term is not due.

If one or more defects are visible, do not

repair the pipe, but replace it.

WARNING! When installation

is complete, make sure that the

seal of each pipe fitting is

correct. Use a soapy solution,

not a flame!

Injectors replacement

1. Remove the pan supports.

2. Remove the caps and crowns of the

burner.

3. With a socket spanner 7 remove the

injectors and replace them with the

ones which are necessary for the type

of gas you use (see table in "Technical

Data" chapter).

4. Assemble the parts, follow the same

procedure backwards.

5. Attach the label with the new type of

gas supply near the gas supply pipe.

You can find this label in the package

supplied with the appliance.

7