4 of 6
Fig. 1 (example of attaching a tool box)
ATTACHING ACCESSORIES:
1. Figure 1 shows an example of a toolbox installed
on a Tool Bar (shown on a tractor 2-Post ROPS).
2. To install an accessory, have both cam levers
rotated UP, then place onto the Tool Bar. See fig.
2.
3. To secure the accessory to the mounting bar,
rotate both cam levers DOWN until they cam over.
See fig. 3.
NOTE: The accessory can be locked to the Tool Bar by
inserting a padlock through the holes in the mounting bracket
where shown.
4. To remove an accessory, rotate both cam levers
UP and lift the unit off of the Tool Bar.
OPERATION
1. Tool Bar fasteners may loosen up over time due to
repeated loading and unloading of accessories. It is
recommended that the fasteners are checked and
retightened, as required, regularly.
2. Multiple Tool Bars can be added to a wall to allow for
more accessories to be attached at a time.
FEATURES AND OPERATION
Fig. 2 (cam lever in the open position)
Fig. 3 (cam lever in the closed position)
rotate both cam levers up
to install an accessory
padlock holes
rotate both cam levers down
to secure the accessory
FEATURES
The Artillian ROPS Mounted Tool Bar Wall Mount allows for one or more Artillian ROPS Mounted Accessories to
be attached to a flat wall. Additional Tool Bars allow for additional accessories.
The innovation of the design is that any of the compatible accessories can be installed or removed from the Tool
Bar in seconds, without the use of tools.
One job may require a toolbox filled with various hand tools. Another might necessitate a tool rack holding
assorted long-handle yard tools or maybe a chainsaw mount and fuel can holder.
With the effortless installation and removal of each accessory, you won’t waste any time setting up your trailer to
carry the specific tool required for the job!
