Setup Hints
10
2.2
Parameterizing the Hardware Configuration (HWC)
It is recommend to have the HWC generated automatically. Use the menu
Hardware
→
Search for Hardware
for this.
If you want to organize or change your HWC manually, you must note how the
ETK Controller (ETKC) counts as well as observing the order of installation in
the ES1000.2 system recommended above:
•
Starting from the left, the ETK ports are referred to as ETKC-A through
ETKC-D. The system controller can operate a maximum of 4 ETK control-
lers.
•
The ETK ports are always numbered consecutively by the system controller.
•
This numbering has to be reflected exactly in the HWC.
The
ETK index
parameter can be selected accordingly in the HWC with the
ETKC device. The following table shows a sample configuration as specified in
the HWC shown below.
The description of the ETK ports in the HWC has to correspond
exactly
to
where the hardware is installed.
ES1201.1 Port A
ETKC-A
ES1201.1 Port B
ETKC-B
ES1200.1 Port A
ETKC-C
ES1200.1 Port B
not assembled
ES1231.1-A Port A
ETKC-D
ES1231_1-ug-en.book Seite 10 Montag, 12. Mai 2003 12:37 12
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
