500-003111-000
5-1
SECTION 5
CONFIGURATION AND INSTALLATION
5.1 UNPACKING
PROCEDURES
* * * * * * * * * * * * * * *
* * * * * * * * * * * * * * *
*
*
*
*
*
*
CAUTION
SOME OF THE COMPONENTS ASSEMBLED ON VMIC'S PRODUCTS MAY BE SENSITIVE TO
ELECTROSTATIC DISCHARGE AND DAMAGE MAY OCCUR ON BOARDS THAT ARE
SUBJECTED TO A HIGH ENERGY ELECTROSTATIC FIELD. UNUSED BOARDS SHOULD BE
STORED IN THE SAME PROTECTIVE BOXES IN WHICH THEY WERE SHIPPED. WHEN THE
BOARD IS TO BE LAID ON A BENCH FOR CONFIGURING, ETC., IT IS SUGGESTED THAT
CONDUCTIVE MATERIAL BE INSERTED UNDER THE BOARD TO PROVIDE A CONDUCTIVE
SHUNT.
Upon receipt, any precautions found in the shipping container should be
observed. All items should be carefully unpacked and thoroughly inspected for
damage that might have occurred during shipment. The board(s) should be checked
for broken components, damaged circuit board(s), heat damage, and
other visible contamination. All claims arising from shipping damage should be
filed with the carrier and a complete report sent to VMIC together with a request for
advice concerning the disposition of the damaged item(s).
5.2 PHYSICAL
INSTALLATION
* * * * * * * * * * * * * * *
* * * * * * * * * * * * * * *
*
*
*
*
*
*
CAUTION
DO NOT INSTALL OR REMOVE THE BOARDS WHILE THE POWER IS APPLIED.
De-energize the equipment and insert the board into an appropriate slot
of the chassis. While ensuring that the board is properly aligned and oriented in
the supporting card guides, slide the board smoothly forward against the mating
connector until firmly seated.
5.3
BEFORE APPLYING POWER: CHECKLIST
Before installing the board in a VMEbus system, check the following
items to ensure that the board is ready for the intended application.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
