138
Tail Chop Pivot position
This value is not active for the CR machine
U
se sort bar if part is longer than:
This value is not active for the CR machine
CRIMPER TAB
Air Feed Die Duration
The duration of time the terminal air feed is on.
Air Feed Die Post Delay
The duration of time the feed actuation is delayed to allow the terminal to clear the applicator.
SYSTEM TAB
Validate materials
This is to activate the Validation mode. This mode will require the operator to use a bar code scanner to validate
the material need for a part before he is allowed to run. See section,
Bar Code Scanning
. For instructions on
how the set up this mode.
Production confirmation
When no boxes are checked.
If in batch mode the machine will move from one batch to the next as long as the collection tray has been
emptied.
If in Job-batch mode the machine will stop when a part is complete, you must press the cycle start button to go to
the next part.
If in Job-harness mode the machine will stop when a harness is complete, you must press the cycle start button to
go to the next part.
When the “At batch/ harness completion” is checked.