172
Installing the 4M collector.
This section is only for when the machine is equipped with a 4M collector.
1.
It is important to note that the height and position of the section of collector bolted to the machine can
be adjusted. This may be necessary for some of the steps below.
2.
Bolt the second section of collector to the first section. You should adjust the feet on the leg under the
joint so that the feet are not touching the floor. This will allow you to move the section around to get
the bolt holes to line up.
4 Bolts on the inside of the collector.
Adjustment
screws
Adjustment
screws