9.10.2. Global settings
We’ll go through the Global settings left to right and top to bottom.
9.10.2.1. Clock In/Out Settings
This is where you determine which clocking signal will be transmitted and recognized by
the Clock input and output connectors. There are four settings: 1pulse, 2pulse (Korg), 24 PPQ,
and 48 PPQ.
9.10.2.2. Auto-Sync
This parameter tells the DrumBrute Impact what to do if it is not running and it receives
a clock signal from an external source. When Auto-Sync is On the unit will respond to the
first clocking signal it receives, and when the clock signal stops the DrumBrute Impact will
switch to Internal clock.
♪
: If the incoming Analog clock signal stops or drops out, the DrumBrute Impact will stop too because
it is not possible to differentiate between a dropped clock signal and a stop.
When Auto-sync is Off the DrumBrute Impact will wait until it receives a signal from the
front panel Sync selection.
9.10.2.3. Tap Tempo
Choose whether it will take 2, 3, or 4 taps to set the Tempo.
9.10.2.4. Global BPM
This parameter allows you to override the independent Tempo settings of each pattern.
When set to Global each pattern will play at the current Tempo value on the front panel.
Arturia - User Manual DrumBrute Impact - MIDI Control Center
94
Summary of Contents for DRUMBRUTE IMPACT
Page 1: ...USER MANUAL...
