10.6.2. The Step encoders: edit, audition
These sixteen encoders will handle most of the editing in Step mode.
From Stop mode or Step Record mode: Select the Pitch track and turn one of the Step
encoders a single click in either direction. This will trigger the recorded note to help identify
the pitch of the selected step. The second click will edit the pitch of that step.
Similarly, when the Gate track is selected, a single click of a Step encoder will show you the
Gate value of that step. This is true of every track type: Velocity, Pressure, Envelope, xV, and
LFO.
♪
: The values shown for each primary and secondary function of the Step encoders are described in
the
section of this chapter. A
chart showing their functions [p.116]
is in the next section.
You can use this technique to discern the value of a Secondary parameter also, on any
track of any type: Hold Shift and turn the Step encoder a single click and the value of that
parameter for that step will be displayed temporarily.
Note: when tracks 3 or 4 are set to Pitch, you can use the Step encoders to view and change
their values but you will not hear the pitch when the encoder is turned.
10.6.2.1. Primary/secondary encoder functions
Here's a chart showing the primary and secondary encoder functions for each track type:
Type
Primary
Secondary
Pitch
Note selection
Slide rate
Gate
Gate length
Step repeat
Velocity
Velocity value
Slide rate
Pressure
Depth
Slide rate
xV
Percentage of selected Voltage
Slide rate
Envelope
Decay of AD envelope
Attack of AD envelope
LFO
Rate
Depth
The Step encoders
116
Arturia - User Manual MiniBrute 2S - Sequence Editing
Summary of Contents for MINIBRUTE 2S
Page 1: ...USER MANUAL...
