14.7.4. CV/Gate settings
This is where you select the electrical behavior for the Control Voltage connectors.
Here’s a quick reference chart for these parameters.
Parameter
Range/Values
Description/Function
CV Pitch Mod1
CV Pitch Mod2
Volts per octave [
]
Hertz per volt [*]
The two standards. Independent settings for each Mod
[*] V/Oct base note
Full MIDI range for
center
[*] With V/Oct selected
[**] Hz/V base note
Full MIDI range for
center
[**] With Hz/V selected
Note Priority
Low, High, Last
Specifies which played note will change the voltage
output
Envelope Retrig
Off, On
Toggles between Legato and Retrigger responses
Pitch Bend Range
1-24
Sets the range for incoming Pitch Bend commands
Velocity Range
1-10
Defines the voltage range of the Velo patch bay jack
Pressure Range
1-10
Defines the voltage range of the Mod patch bay jack
V/Oct
Base
Note
Pitch
Full MIDI range
Sets the center reference point for the KBD patch bay
jack
Now we’ll take a look at each of those parameters.
14.7.4.1. CV Pitch (Mod 1, 2)
The CV Pitch Mod1 and CV Pitch Mod2 parameters are identical so we'll cover them both
here.
The various models of vintage gear respond differently to electricity. MiniBrute 2S works
well with the most common types.
• V/Oct (1Volt per octave) – This is the standard used on most Eurorack modules
and on Arturia's Brute series of synthesizers.
• Hz/V (Hertz per Volt) – This is the technology used by Korg and older Yamaha
synthesizers.
154
Arturia - User Manual MiniBrute 2S - MIDI Control Center
Summary of Contents for MINIBRUTE 2S
Page 1: ...USER MANUAL...
