7.13.3. Sync & Run
Look closely at the two jacks on the bottom of the Sequencer section. You'll see a small
arrow between them:
The arrow indicates that the Sync and Run jacks are permanently related: When the
Sequencer starts it sends clock information to the Sync jack and a trigger voltage to the Run
jack.
7.13.3.1. Use a TRS cable between two Arturia products
A single TRS cable is all you need to synchronize the sequencers of two MiniBrute 2 units, or
the sequencers of the MiniBrute 2S and another Arturia product such as the MatrixBrute, the
BeatStep Pro, or the KeyStep. These products send and receive their Sync and Start signals
from a single jack. Simply connect one TRS patch cable from the Sync jack of the master
MiniBrute 2S to the Clock input of the slaved Arturia device (or vice versa) and the slave will
start, pause, resume playback, and restart from the beginning whenever the master does.
Remember to set the Sync of the slave device to Ext and set both devices to the same clock
rate (i.e., 24 ppq). On the MiniBrute 2S, hold the Sync button and turn the Tempo/Value knob
to select the desired clock rate.
Sync > Run are
interrelated jacks
Arturia - User Manual MiniBrute 2S - The Patch bay
79
Summary of Contents for MINIBRUTE 2S
Page 1: ...USER MANUAL...
