7.13.3.2. Use two TS cables between MiniBrute 2S and other devices
Most modular systems do not use TRS cables or connectors, so when working with those
systems you will need to use two TS cables between the MiniBrute 2S and the modular
system.
•
MiniBrute 2S as master:
Connect one TS cable from the MiniBrute 2S Sync out
jack to the clock input of the slave device, and connect a second TS cable from
the MiniBrute 2S Run output jack to the run/reset input of the slave device.
•
MiniBrute 2S as slave:
Connect one TS cable from the Clock/Sync output of the
master device to the Clock input jack of the MiniBrute 2S (and set its Sync LED to
CLK), and connect the second TS cable from the Run/Reset output of the master
device to the Reset input jack of the MiniBrute 2S.
♪
: Be sure to match the clock rates between the two devices. On the MiniBrute 2S, hold the Sync
button and turn the Tempo/Value knob to select the desired clock rate.
When the devices are connected as described above and set to the same synchronization
standard, the system will sync perfectly:
• If the Master unit is stopped and then restarted, the Reset input on the slave
will receive a Run/Reset trigger and the unit will play its sequence from the
beginning.
• If the Master unit is paused and then playback is resumed, the Reset input on the
slave will not receive a Run/Reset trigger and the unit will continue to play from
the middle of its sequence, not from the beginning.
80
Arturia - User Manual MiniBrute 2S - The Patch bay
Summary of Contents for MINIBRUTE 2S
Page 1: ...USER MANUAL...
