ARTURIA – ORIGIN – USER’S MANUAL
126
-
[
Mix
]: Mix of negative and positive translations output connection
-
[
Output A
]: Positive translation output connection
-
[
Output B
]: Negative translation output connection
9.1.2.6
Joymixer
The [Joymixer] lets you mix the four audio sources (eg. oscillators, filters) in order to enrich and
develop the sound. This mix is done with a joystick moving between four points (A, B, C, and D)
representing the maximum volume of each of the audio sources. You can also automate the
modulation of the X and Y axis by connecting modulation sources (eg. LFO, envelopes…). The mix
can also be dynamically automated by an envelope defining four periods, each of which corresponds
to a position to which the joystick can be programmed.
The 2D envelope emulates the movements of the joystick designating a time to each of the four
movements (points 0 to 4) and during the length of a note.
The joy(stick)mixer
To position the four points on the virtual joystick area, on the screen:
Select the joystick area with the [
◄
/
►
] /or [
▲
/
▼
] buttons and press the jog dial to validate
the selection (highlighted in red).
Move the joystick to the place you want. The first point of the joystick moves on the screen
(value “4” is indicated at first). Select the second point by pressing the [
◄
/
►
] or [
▲
/
▼
] buttons
and do the same for the other points.
From there, the only modifiable parameters are the durations of the movements of the joystick
between each point labeled “T1” to “T5”.
-
[
Env 2D
]: This button activates the 2D Envelope
-
[
Loop mode
]: The LOOP mode function applies a loop between some points of the
envelope (OFF, 0>3; 1>3; 2>3 or 0<>3; 1<>3; 2<>3). When the key is released, the loop is
interrupted, and goes from last reached point to point 4.
-
[
Repeat
]: The “REPEAT” function repeats the movement cycle of the joystick (from 1 to
7, or indefinitely
C
yclic).
-
[
T1…T5
]: Set the 5 values of times for automate the movements of the joystick between
each point.
•
The Input connections:
-
[
Trig
]: Input trigger signal connection for the 2D envelope.
-
[
Audio A…D
]: These are the dedicated inputs for an audio module on each of the 4
joystick points.
-
[
Mod X
]: Connect a modulation sources to automate the modulation of the X axis.
-
[
Mod Y
]: Connect a modulation sources to automate the modulation of the Y axis.