21
04
[05]
x 4
[05]
∅120
225
275
75
478
510
302
12
170
453
B
A
MOUNTING THE HOOD UNDERNEATH A CUPBOARD
Both extraction and recirculation options can be used
EXTRACTION
Cut a hole in the cupboard base to suit the position of the exhaust vent in the visor
hood and size to suit the vent kit being used.
Connect collar vent kit.
Using 4 screws [05] attach the cooker hood to the underside of the cupboard using
the 2 hole position (A) and 2 hole position (B).
Connect vent kit as per manufactuers instructions if applicable .
Important:
The exhaust air must not be expelled through a smoke or waste gas
chimney, which is in use,or through a shaft used for ventilating rooms or into the cavity
of a wall.
RECIRCULATION
Care and maintenance
section
Important
:
central heating boiler, which is not of the ‘Balanced Flue’ type, you should make sure
that there is adequate air inlet into the room at all times so that fumes from the boiler
are not drawn back into the room by the Cooker Hood.
For electrical connection see
Technical and legal information
section.
Using 4 screws [05] attach the cooker hood to the underside of the cupboard using
the 2 hole position (A) and 2 hole position (B).