Aruba Networks PowerConnect W-AP124 Installation Manual Download

Page: 4 / 8

AP-120-MNT-CV Access Point Enclosure

| Installation Guide

5. Complete the installation process as follows (

Figure 5

a. Align the mounting posts on the mounting plate with the mounting holes on the back of the AP.

b. Push the AP against the pegs and downward, until the pegs engage the slots at the top of the

mounting holes.

c. (Optional) Extend right and left antennas vertically before installing the cover.

d. Once the AP is securely attached to mounting plate, install the cover by placing the hooks on the

cover into the holes on the bottom of the base. Push the top of the cover towards to base until it
clicks into places.

Figure 5

Completing the installation

Figure 6

Completed wall installation

AP120_002

Summary of Contents for PowerConnect W-AP124

Page 2: ...d junction box Figure 1 Save the screws Figure 1 Removing the installed cover plate b Identify the Ethernet cable or cables that will be connected to the AP 121 or AP 125 The Ethernet cable must have a male RJ 45 connector c Attach the mounting plate to the junction box using the screws from the removed cover plate Figure 2 Figure 2 Installing the mounting plate AP120_001 ...

Page 5: ...on a ceiling rail 1 Place the AP into the base Figure 7 Place the top AP into the hooks on the base and align the back of the AP with the large opening in the base Figure 7 AP Installed in base 2 Install the ceiling rail adapter that matches your ceiling rails Figure 8 Figure 8 Installing the AP ceiling rail adapter 3 AP120_007 ...

Page 7: ...end The access is shown in Figure 11 8 Once the AP is secured to the ceiling rail install the cover by placing the hooks on the cover into the holes on the bottom of the base Figure 11 Push the top of the cover towards to base until it clicks into places Figure 11 Installing the cover Figure 12 Completed ceiling installation AP120_002 Access cutout ...