Aruba Networks PowerConnect W-AP124 Installation Manual Download

Page: 6 / 8

AP-120-MNT-CV Access Point Enclosure

| Installation Guide

3. Pull the necessary cables through a prepared hole (

Figure 9

) in the ceiling tile near where the AP

will be placed.

4. Connect the ethernet cable or cables to the AP. Ensure that the cables do not obstruct any of the

connection points between the base and the cover.

Figure 9

Cable path

5. Hold the enclosure base next to the ceiling rail with the ceiling rail at approximately a 30-degree

angle to the ceiling tile rail (

Figure 10

6. Rotate the enclosure base clockwise until the device clicks into place on the ceiling rail.

Figure 10

Installing the AP on a ceiling rail

AP120_009

AP120_008

Summary of Contents for PowerConnect W-AP124

Page 2: ...d junction box Figure 1 Save the screws Figure 1 Removing the installed cover plate b Identify the Ethernet cable or cables that will be connected to the AP 121 or AP 125 The Ethernet cable must have a male RJ 45 connector c Attach the mounting plate to the junction box using the screws from the removed cover plate Figure 2 Figure 2 Installing the mounting plate AP120_001 ...

Page 5: ...on a ceiling rail 1 Place the AP into the base Figure 7 Place the top AP into the hooks on the base and align the back of the AP with the large opening in the base Figure 7 AP Installed in base 2 Install the ceiling rail adapter that matches your ceiling rails Figure 8 Figure 8 Installing the AP ceiling rail adapter 3 AP120_007 ...

Page 7: ...end The access is shown in Figure 11 8 Once the AP is secured to the ceiling rail install the cover by placing the hooks on the cover into the holes on the bottom of the base Figure 11 Push the top of the cover towards to base until it clicks into places Figure 11 Installing the cover Figure 12 Completed ceiling installation AP120_002 Access cutout ...