NOTE:
The Aruba JL258A and JL692A 8-port switches have a fan-free design, making them quiet for office
deployments. A warmer than normal enclosure is a standard state of operation for a fan-free switch. Although
the top of the switch enclosure may feel warm to the touch, it has no effect on functionality or performance of
the product. For rack-mounted Aruba 8-port 2930F fanless switches, ensure that a 1U (44.45 mm / 1.75-inch)
vertical space is left between the switch and the device above it.
Power cords
Aruba includes the power cord intended for use with your Aruba switch. Different countries/regions may require different
power cords. For a list of the power cords that apply to your Aruba 2930Fswitch, see the section that lists power cords in
the latest edition of the
Aruba 2930F Switch Series Installation and Getting Started Guide
.
CAUTION:
Only Aruba-approved power cords may be used with Aruba devices. To access the power cord
information for your switch, see the latest edition of the
Aruba 2930F Switch Series Installation and Getting
Started Guide
. Lost or damaged power cords must be replaced only with Aruba-approved power cords. If
your installation requires a different power cord than the one supplied with the switch and/or power supply, be
sure that the cord is adequately sized for the current requirements of the switch. In addition, be sure to use a
power cord displaying the mark of the safety agency that defines the regulations for power cords in your
country/region. The mark is your assurance that the power cord can be used safely with the switch and
power supply.
WARNING:
Do not use a damaged or nonrecommended power cord with your switch. Using such power
cords voids the switch and power supply warranty. It can also cause serious electrical problems, including
injury or death to personnel, and damage to the switch and other property. If you cannot verify that you have
a power cord approved for use with your switch model, contact your authorized Aruba dealer or sales
representative for assistance.
WARNING:
Remove the power cord from the switch before mounting or dismounting the switch.
Aruba 2930F switch safety and regulatory information
NOTE:
For important safety, environmental, and regulatory information, see
Safety and Compliance
Information for Server, Storage, Power, Networking, and Rack Products
support/Safety-Compliance-EnterpriseProducts
Table 1: Electrical information for 2930F switches requiring direct AC voltage
Maximum current
AC Voltage
Frequency range
24G non-PoE 4SFP + (JL253A)
0.6A for 100-127VAC
0.4A for 200-240VAC
100-127 / 200-240
50/60 HZ
48G non-PoE 4SFP + (JL254A)
0.9A for 100-127VAC
0.6A for 200-240VAC
24G 4SFP (JL259A)
0.6A for 100-127VAC
0.4A for 200-240VAC
Table Continued
Page 3
