8
|
Rev 01|October 2021
l
Humidity: 5% to 93% non-condensing
n
Storage
l
Temperature: -40ºC to 70ºC (-40ºF to 158ºF)
l
Humidity: 5% to 93% non-condensing
Regulatory Model Number
For the purpose of regulatory compliance certifications and identification, this product has been assigned a
unique regulatory model number (RMN). The regulatory model number can be found on the product
nameplate label, along with all required approval markings and information. When requesting compliance
information for this product, always refer to this regulatory model number. The regulatory model number
RMN is not the marketing name or model number of the product.
The following regulatory model numbers apply to the 650 Series
n
AP-655 RMN: APIN655
Safety and Regulatory Compliance
RF Radiation Exposure Statement:
This equipment complies with RF radiation exposure limits. This equipment
should be installed and operated with a minimum distance of 13.78 inches (35cm) between the radiator and your body
for 2.4 GHz and 5 GHz operations. This transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.
Déclaration e la concernant l’exposition aux rayonnements à fréquence radioélectrique (FR): Cet appareil est conforme
aux limites d’exposition aux rayonnements FR établies par la FCC. Il doit être installé et utilisé à une distance minimale
de 35 cm (13,78 pouces) entre le radiateur et votre corps, qu’il opère sur la bande 2,4 GHz ou 5 GHz. Cet émetteur ne
doit pas être installé ou utilisé à proximité immédiate d’une autre antenne ni d’un autre transmetteur.
The device could automatically discontinue transmission in case of absence of information to transmit, or operational
failure. Note that this is not intended to prohibit transmission of control or signaling information or the use of repetitive
codes where required by the technology.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s author-
ity to operate this equipment.
Toute modification effectuée sur cet équipement sans l'autorisation expresse de la partie responsable de la conformité
est susceptible d'annuler son droit d'utilisation.
United States
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)this
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the manufacturer’s instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures
n
Reorient or relocate the receiving antenna.
n
Increase the separation between the equipment and receiver.
