AP-220-MNT-W2 Mounting Kit
Installation Guide
0511290-05 |
October 2014
1
Package Contents
AP-220-MNT-W2 Mounting Bracket
Plastic Shim
2x Ethernet Cable Adapter
T10 Torx Security Screw
Installation
Complete the following steps to install your access point using the AP-220-MNT-W2.
Ethernet Cable Routing Options
There are three options for routing the Ethernet cable depending the placement of your AP in relation to the
source of the Ethernet cable.
Ethernet Cable From Below AP
1. Route the Ethernet cable(s) through the channel in the rear of the mount.
2. Loop the Ethernet cable(s) over the top of the mount and direct the cable(s) through the opening leading
to the AP’s Ethernet ports.
3. If required, route the power cable through the bottom right of mounting bracket.
4. Install the mounting bracket as described in
“Installing the Mounting Bracket” on page 3
.
Figure 1
Ethernet cable from below the AP
N O T E
This mount kit supports multiple AP models. All installation images show the 225 AP.
