Aruba EC-10104, Installation Manual

Aruba EdgeConnect 10104 SD-WAN Gateway

| Installation Guide

EC-10104 SD-WAN Gateway |

6

Aruba EdgeConnect 10104 SD-WAN Gateway Components

This section introduces EC-10104 SD-WAN Gateway components and their location on the 

gateway.

Figure 1

 shows the front panel of the EC-10104. 

Figure 2

 shows the back panel of the EC-10104. 

Figure 1  

Front Panel of the Aruba EdgeConnect 10104 SD-WAN Gateway

Figure 2  

Back Panel of the Aruba EdgeConnect 10104 SD-WAN Gateway

Front Panel LED

The front panel LED show the power status of the EC-10104. The following table describes the 

LED indicators and their corresponding status:  

DC Power Connector

The AC-DC adapter kit with the following specification is used to power the EC-10104.



12V/2.5A power interface



Center-positive 2.1/5.5 mm circular plug, 9.5 mm length

Ethernet Ports

The EC-10104 SD-WAN Gateway is equipped with four 10/100/1000BASE-T Gigabit Ethernet ports 

(Lan0, LAN1, Wan0, and Wan1). Gigabit Ethernet uses all eight wires and each pair is bidirectional, 

which means the same pair is used for both data transmission and reception. 

Figure 3

 illustrates 

the Gigabit Ethernet port pin- out for an RJ-45 connector. The pins paired on a 10/100/1000Base-

T Gigabit Ethernet port are: 1/2, 3/ 6, 4/5, and 7/8.

Table 4  

LED Status

LED

Function

Indicator

Status

Power

Power Status

Green (Solid)

Powered and Operational

Off

Power Off