Aruba EC-10104 SD-WAN Gateway
| Installation Guide
Installation |
11
Wall-Mounting Installation Instructions
The keyhole-shaped slots on the bottom of the gateway can be used to attach the device upright
(back port facing downwards) to an indoor wall or shelf.
Make sure to mount the gateway in such a way that there is a clear path to the Ethernet port, such as
a predrilled hole in the mounting surface.
1. At the mounting location, install two screws on the wall or shelf, 145.35 mm apart. If you are
attaching the device to drywall, it is recommended that you use appropriate wall anchors
(included in the package). See
.
Use 3/4 inch long #6 pan head wood screws for mounting the gateway on wood.
Use 3/4 inch long #6 pan head wood screws with plastic screw anchor #6-8 x 1 inch on dry wall
or concrete wall.
Required quantity: 2 screws per unit
Screws can be installed at the required location by using the provided template.
Figure 7
Mounting Using the Integrated Wall-Mounting Slots
2. Align the mounting slots on the bottom of the gateway over the screws and slide the unit into
place. See
.
Figure 8
Wall Mounting Aruba EdgeConnect 10104 SD-WAN Gateway
145.35 mm
