Aruba EC-10104 SD-WAN Gateway
| Installation Guide
Installation |
12
Rack Mounting Installation Instructions
This mounting option allows mounting the EC-10104 SD-WAN Gateway in a two-post 19-inch Telco
rack with either the front panel facing outward or the rear panel facing outward using the Aruba
10104-MNT-19 Rack Mount Kit (additional accessory).
Required Tools and Equipment
The following tools and equipment are required for installing an EC-10104:
Rack mount tray (x1) for rack mounting installation
Rubber clamps (x2) for securing the power adapter on the rack mount tray (included in the kit)
M3 x 5 mm flat head screws (x4) for securing the gateway on the rack mount tray (included in the
kit)
M6 x 15 mm Phillips pan head screws (x4) for rack mount (included in the kit)
Suitable screwdrivers for all screw types provided in the box (not included in the kit)
Installation Steps
To install an EC-10104 into a two-post 19-inch Telco rack with the front panel outwards, perform the
following steps:
1. Align the EC-10104 to the screw hole provided on the rack mount tray. See
.
2. Align the screws under the rack mount tray and tighten the screws to secure the gateway on the
rack mount tray. See
Figure 9
Aligning the Aruba EdgeConnect 10104 SD-WAN Gatewaywith the Rack Mount Tray
3. Use the rubber clamps provided with the kit to secure the power cable with the power adapter.
Each EC-10104 SD-WAN Gateway should have its own mounting equipment. Do not place other networking equipment
directly on top of a mounted SD-WAN Gateway. Failure to do so can damage the device.
Some racks require screws that differ from those included with the EC-10104 SD-WAN Gateway kit. Ensure that you have the
correct screws before installing the device.
1
2
