Aruba EdgeConnect 10104 SD-WAN Gateway
| Installation Guide
Configuring the Gateway |
16
Chapter 3
Configuring the Gateway
Install the Gateway into the Network
All copper RJ-45 Gigabit Ethernet interfaces in the gateway support MDI/MDI-X and auto-negotiation.
To install the gateway into the network, perform the following:
1. Identify the relevant ports on the rear of the gateway.
2. Connect network cables from the gateway to the identified network equipment ports.
Figure 17
Connecting the Gateway to Network Equipment Ports.
Connect Power Cords
1. Connect the power adapter DC connector to the EC-10104 SD-WAN Gateway.
2. Plug the power cord female end to the power adapter and the male end to your local power
source.
Turn the Power On
The gateway powers up as soon as it is plugged into the local power source. On the front panel, verify
the Power LED illuminates green.
IMPORTANT - READ THIS FIRST: You must install and register your Orchestrator with the Aruba Cloud Portal
BEFORE setting up an EdgeConnect gateway. After Orchestrator is registered with your account name and key,
you can proceed with EdgeConnect installation. If you don’t know or are unsure wht role the Orchestrator
plays, please contact your network architect or deployment lead.
lan0
wan0
Router / CPE
wan1
Router / CPE
Switch
lan1
lan0
wan1
wan0
RJ-45
cable
RJ-45
cable
copper
Internet (ISP-1)
MPLS
or
Internet (ISP-2)
