Parameter
Description
Client match
Select
Enabled
to enable the
Client match
feature on IAPs. When enabled,
client count will be balanced among all the channels in the same band. For
more information, see
. By default, the client match
feature is disabled.
NOTE:
When client match is enabled, ensure that
is enabled.
CM calculating
interval
Specify a value for calculating the interval of Client match. The value specified
for
CM calculating interval
determines the interval at which client match is
calculated. The interval is specified in seconds and the default value is 30
seconds. You can specify a value within the range of 10–600.
CM neighbor
matching %
Specify a value for
CM neighbor matching %
. This number takes into account
the least similarity percentage to be considered as in the same virtual RF
neighborhood of client match. You can specify a percentage value within the
range of 20–100. The default value is 75%.
CM threshold
Specify a value for
CM threshold
. This number takes acceptance client count
difference among all the channels of client match into account. When the client
load on an IAP reaches or exceeds the threshold, client match is enabled on
that IAP.
You can specify a value within range of 1–255. The default value is 2.
SLB mode
Select a mode from the
SLB mode
drop-down list. The SLB mode determines
the balancing strategy for client match. The following options are available:
l
Channel
l
Radio
l
C Radio
Table 55:
Client Match Configuration Parameters
2. Click
OK
.
In the CLI
(Instant AP)(config)# arm
(Instant AP)(ARM)# client-match calc-interval <seconds>
(Instant AP)(ARM)# client-match calc-threshold <threshold>
(Instant AP)(ARM)# client-match nb-matching <percentage>
(Instant AP)(ARM)# client-match slb-mode 1
(Instant AP)(ARM)# end
(Instant AP)# commit apply
Access Point Control
You can configure access point control parameters through the Instant UI or the CLI.
In the Instant UI
1. For
Access Point Control
, specify the following parameters in the
RF > ARM > Show advanced options
tab:
Aruba Instant 6.5.0.0-4.3.0.0 | User Guide
Adaptive Radio Management |
257