You can configure up to 128 access rules for an Employee, Voice , or Guest network using the Instant UI or the
CLI.
In the Instant UI
To configure access rules for an Employee or Voice network:
1. In the
Access Rules
tab, set the slider to any of the following types of access control:
l
Unrestricted
—Select this option to set unrestricted access to the network.
l
Network-based
—Set the slider to
Network-based
to set common rules for all users in a network. The
Allow any to all destinations
access rule is enabled by default. This rule allows traffic to all
destinations.
To define an access rule:
a. Click
New
.
b. Select appropriate options in the
New Rule
window.
c. Click
OK
.
l
Role-based
—Select this option to enable access based on user roles. For role-based access control:
n
Create a user role if required. For more information, see
.
n
Create access rules for a specific user role. For more information, see
. You can also configure an access rule to enforce captive portal
authentication for an SSID that is configured to use 802.1X authentication method. For more
information, see
Configuring Captive Portal Roles for an SSID on page 138
n
Create a role assignment rule. For more information, see
Configuring Derivation Rules on page 201
2. Click
Finish
.
In the CLI
To configure access control rules for a WLAN SSID:
(Instant AP)(config)# wlan access-rule <name>
(Instant AP)(Access Rule <name>)# rule <dest> <mask> <match> {<protocol> <start-port> <end-
port> {permit|deny|src-nat [vlan <vlan_id>|tunnel]|dst-nat{<IP-address> <port>|<port>}}| app
<app> {permit|deny}| appcategory <appgrp>|webcategory <webgrp> {permit|deny}| webreputation
<webrep> [<option1....option9>]
(Instant AP)(Access Rule <name>)# end
(Instant AP)# commit apply
To configure access control rules based on the SSID:
(Instant AP)(config)# wlan ssid-profile <name>
(Instant AP)(SSID Profile <name>)# set-role-by-ssid
(Instant AP)(SSID Profile <name>)# end
(Instant AP)# commit apply
To configure role assignment rules:
(Instant AP)(config)# wlan ssid-profile <name>
(Instant AP)(SSID Profile <name>)# set-role <attribute>{{equals|not-equals|starts-with|ends-
with|contains|matches-regular-expression}<operator><role>|value-of}
(Instant AP)(SSID Profile <name>)# end
(Instant AP)# commit apply
To configure a pre-authentication role:
(Instant AP)(config)# wlan ssid-profile <name>
(Instant AP)(SSID Profile <name>)# set-role-pre-auth <role>
(Instant AP)(SSID Profile <name>)# end
(Instant AP)# commit apply
Aruba Instant 6.5.0.0-4.3.0.0 | User Guide
Wireless Network Profiles |
99
