In the Spectrum Monitor mode, the IAPs do not provide access services to clients.
4. Click
OK
.
In the CLI
To configure a radio profile:
(Instant AP)# wifi0-mode {<access> | <monitor> | <spectrum-monitor>}
(Instant AP)# wifi1-mode {<access> | <monitor> | <spectrum-monitor>}
If the access mode is configured, you can configure the channel and transmission power by running the
following commands:
(Instant AP)# a-channel <channel> <tx-power>
(Instant AP)# g-channel <channel> <tx-power>
Configuring Maximum Clients on SSID Radio Profiles
You can also set the maximum number of clients individually for SSID profiles operating on the 2.4 GHz and 5
GHz radios. This configuration is not persistent and is lost once the IAP is rebooted.
To configure maximum clients for an SSID radio profile in the prilvileged exec mode:
(Instant AP)# a-max-clients <ssid_profile> <max-clients>
(Instant AP)# g-max-clients <ssid_profile> <max-clients>
To view the maximum clients allowed for an SSID profile:
(Instant AP)# show a-max-clients <ssid_profile>
(Instant AP)# show g-max-clients <ssid_profile>
You can also set the maximum clients when configuring SSID profiles using the
Max Clients Threshold
parameter in the Instant UI and
max-clients-threshold
parameter in the Instant CLI. For more information,
see
Configuring WLAN Settings for an SSID Profile on page 82
.
If the maximum clients setting is configured multiple times, using either the configuration mode or Privileged
EXEC mode, the latest configuration takes precedence.
Configuring Uplink VLAN for an IAP
Instant supports a management VLAN for the uplink traffic on an IAP. You can configure an uplink VLAN when
an IAP needs to be managed from a non-native VLAN. After an IAP is provisioned with the uplink management
VLAN, all management traffic sent from the IAP is tagged with the management VLAN.
Ensure that the native VLAN of the IAP and uplink are not the same.
You can configure the uplink management VLAN on an IAP by using the Instant UI or the CLI.
In the Instant UI
To configure uplink management VLAN:
1. On the
Access Points
tab, click the IAP to modify.
2. Click the
edit
link.
3. Click the
Uplink
tab.
4. Specify the VLAN in the
Uplink Management VLAN
text box.
Aruba Instant 6.5.0.0-4.3.0.0 | User Guide
Customizing IAP Settings |
72
