Parameter
Factory Default Setting
Subnet mask
255.255.255.0
Default gateway
not set
To communicate with the switch using the 192.168.1.1 address:
1. Connect a PC directly to any of the switch’s network ports using a standard Ethernet cable.
2. Configure the PC’s IP Address and Subnet Mask to allow it to communicate with the switch through your
PC’s Web browser.
3. Click Use the following IP address, and then, in the IP address and Subnet mask fields, type the IP
address settings:
a. For IP address, enter an IP address in the same range as the switch’s IP address, for example, enter
192.168.1.12.
b. For Subnet mask, enter 255.255.255.0, then click OK.
c. Click Close (or OK) to close the Local Area Connection Properties screen.
4. Open the Web browser on the PC, and enter the switch address, http://192.168.1.1 to access the switch’s
Web interface.
Where to go from here
For more information on the local web interface and all the features that can be configured on the 1930
Switch Series, see the Aruba Instant On 1930 Switch Series Management and Configuration Guide.
For more information on using the Aruba Instant On Portal to manage the switch, see the Aruba Instant On
User Guide.
Chapter 5 Initial configuration
39
