MSX 8 Owner's Manual v 3 CE ©2010 ARX®
MSX 8 Owner's Manual v 3 CE ©2010ARX®
7
Specifications
Signal / Noise Ratio
-94dB
Distortion
.008% 20Hz - 20KHz
Gain through unit
Switchable 0, +10, +20, +30, +40 dB
Maximum Output
+24dB
Pad Switch
–20dB attenuation
Phantom Power
+48VDC slow turn on/turn off
Output Impedance
100 Ohms Electronically Balanced
(Optional 600 Ohm Transformer balancing available)
Clip LED
1dB before clipping
AC Mains Input
Fused IEC socket
AC Power
100-120V AC 1 amp
220-240V AC 0.5 amp
Transformer Type
Low-noise shielded toroidal
Size
19”W x 1¾”H x 6”D
482 x 44 x 155 mm
Weight
5 lbs (2.2 Kg)
Complete online documentation is available on the ARX website:
www.arx.com.au/msx8.htm
Specific queries can be emailed to the factory at
info@arx.com.au
ARX® is a Registered Trade Mark of ARX Systems Pty Ltd. MSX 8™ is
a trade mark or ARX Systems Pty Ltd. Any other names and trademarks
are used for information purposes only, and no other intent is expressed
or implied
This symbol indicates that a Slow Blow fuse
is used in this equipment. Replace with same
type and value only
This symbol is intended to alert you to the
presence of uninsulated dangerous voltage
within the product's enclosure that may be of
sufficient magnitude to constitute a risk of
electric shock.
This symbol is intended to alert you to the
presence of important operating instructions
contained in this owner's manual
WARNING SYMBOLS USED
ON THIS EQUIPMENT
IMPORTANT
- PLEASE READ THIS FIRST
THIS IS A DUAL VOLTAGE UNIT. IT IS ESSENTIAL THAT YOU CHECK THAT THE VOLTAGE
ON THE FUSEHOLDER COVER BELOW THE AC CONNECTOR ON THE REAR OF THE
CHASSIS IS SET CORRECTLY BEFORE CONNECTING IT TO AC POWER.
To change, pull fuseholder out and rotate 180
o
, then push in again. Do not insert power
cable into unit until voltage has been correctly set. Do not connect power cable to AC
power until voltage has been correctly set
THIS IS SET FOR 100 V
AC TO 120 V AC
OPERATION
THIS IS SET FOR 220 V
AC TO 240 V AC
OPERATION
Complies with 89/336/EEC EMC Directive,
amended by 92/31/EEC and 93/68/EEC;
meets the following standards:EN 55013 :
1990, Sections 3.2 and 3.5, EN 55020 : 1988,
Sections 4.3, 5.4, 6.2, 7.0, 8.0., and EN
60950 : 1994 Low Voltage Directive
Complies with Australian Standard AS/N25
1053
Our policy is one of continuous improvement,
and therefore designs may change without
notice. However, unless otherwise stated,
specifications will always equal or exceed
those previously given.
