FILLING WITH WATER
1. Unplug the iron and remove the iron from its
charging base.
2. Set the steam ruler to dry ironing.
3. Fill the tank through the filling hole. Use the water
filling beaker to pour water slowly into the filling hole.
Do not fill higher than indication ‘MAX’ of the water
tank.
4. If you have hard water ,it is advisable to use only distilled or
demineralized water.
5. You can use tap water, unless it is very hard. Otherwise, it is advisable
to use distilled water.
CAUTION: Do not use chemically de-limed water or perfumed water.
DRY IRONING
•
Place your iron on a flat surface and on its charging
base and insert the plug.
•
Set the variable steam button to the position of “
“. This will prevent the steam flow; even there is
water in the water tank.
•
Adjust the temperature switch according to the
kind of fabrics you want to iron.
•
You can start ironing after the emperature display
light disappears, indicating that the selected
temperature is being maintained.
•
When you pause the ironing process, place the
iron on its charging base in an upright position.The thermostat light will
turn on, when the soleplate of your iron reaches the desired temperature,
the thermostat light will turn off and your iron will be
ready for ironing again.
NOTE: Thermostat display light may again turn on
to maintain the selected temperature of soleplate
during ironing,which is suitable for the article being
ironed.
STEAM IRONING
1.Fill the iron as described in the section “how to fill
the water tank”.
2. Plug the iron into the mains.
17
ARZUM
EN