3.Steam ironing is only possible when the highest temperatures shown on
the temperature control are selected .
Otherwise ,water may escape through the soleplate.
4. Wait until the pilot light goes out , which indicates that the selected
temperature has been reached.
5.Turn the steam button to the required position.
6.When you pause the ironing process, place the iron on its base in an
upright position.
7.Disconnect the iron from the mains supply . Pour of any remaining water
and leave the iron to cool off.
SPRAYING
1.The spray can be used in any position, either in dry or steam ironing, as
long as the water tank is filled with water.
2.Press the spray button for this function
NOTE
: This button has to be pressed repetitively to start this function for
the first time.
SHOT OF STEAM
Shot of steam give extra steam for removing persistent wrinkles.
1.Place the temperature selector at the “max”position and wait until the pilot
light goes out
2.Wait for a few seconds for the steam to penetrate the fibre before
pressing again.
NOTE : For the best steam quality, do not use more than three successive
bursts each time. Several pumping actions are needed to start this
function.
Excessive use of this feature will cause the iron to cool , ensure that the
pilot light is out, before operating the shot of steam control
DETACHABLE CHARGING BASE
The charging base provides power. The base can
be separated from the electric iron. Charging base
can rotate 360°. When the base is electrified, the
indicator light is on. You can also use your iron as
a cable. For this; You can lock the base and iron by
bringing the lock button on the bottom to the ( ) sign.
18
ARZUM
