Page 27 / 49
11
OPERATION OF THE MACHINE
11.1
Using a new machine
The life of a new machine depends on the way it is operated and maintained. New machines
directly from the factory are of course thoroughly tested, but the different parts are not jet
adapted to one another. It is therefore important to drive at a reasonable speed and avoid
extreme strain during the initial 50 hours of operation, to allow all parts to run in.
The life of the machine depends highly on the way the machine is taken care of during the
running-in period. The running-in is very important for an optimum output and lifetime of the
machine. The following precautions should therefore be taken:
Running-in period.
Change motor oil and hydraulic oil filter after the first 20 hours of operation.
11.2
Controls to be carried out before start
1.
Check if there is enough petrol in the fuel tank (octane 86 or higher).
2.
Check the hydraulic oil level – must stand to the mark at the oil gauge dipstick.
3.
Check the motor oil level. The oil must stand to the maximum level.
4.
Check if the flails of the mower are undamaged. Replace any damaged flails. Driving
with damaged flails can cause imbalance of the mower and an unsatisfactory mowing
result.
5.
Clean the air filter of the motor.
6.
Check the V-belts and lubricate bearings and bushings according to the lubricating
schedule.
