LED Spotlight 20W
Article: 46925 - LED-Spotlight with 20W LED with 2m H05RN-F 3G1,0
Introduction
Please read the instruction manual completely and carefully.
The LED spotlights have been designed to be used in protected outdoor locations.
If the safety guidelines are not adhered to, life threatening situations and injuries as well as
technical malfunctions (electrical shock, shortcircuit, fire, etc.) can result.
The LED spotlights are intended to be used in dry indoor locations as well as for permanent
use in outdoor locations.
Technical data
Nominal voltage: 220-240 V AC
Nominal frequency: 50-60 Hz
Protection class: IP 65
LED class: I
Light colour: 6400K
ca. 1500Lumen
Connection
DANGER: Mounting must be carried out by a professional. The person must be familiar
with the relevant norms, regulations and dangers.
1 Disconnect the circuit
It is imperative to disconnect the chosen circuit.
Danger: Check absence of voltage.
2 Open connection box
Unscrew the two Phillips screws from the connection box.
3 Insert cable
Unscrew the screws from the cable gland, mains lead cleat and connection brackets.
Lead the stripped connection cable through the cable gland into the box.
4 Wiring the LED spotlight
Connect brown (i.e. black) cable to bracket L, the blue cable to N and thegreen / yellow onto
the protective earth bracket. (See
connection plan in theconnection box)
L = carrying conductor (phase)
N = neutral conductor (neutral)
= protective earth (grounding)
Screw the screws from the cable gland,mains lead cleat and connection brackets back on.
5 Close connection box
Close the connection box with the lid and screw closed.
Safety Precautions:
To reduce risk of electric shock, this product should ONLY be opened by an authorized
technician when service is required.
Disconnect the product from mains and other equipment if a problem should occur.
