Asada 380SP, Instruction Manual

PIPE SAW 380SP

11

OPERATION

● Before starting operation, always read the instructions in "SAFETY INSTRUCTIONS" and 

"OPERATING INSTRUCTIONS" (pages 2 to 6).

◆ The extension cord used should be without damage. 

A failure to do so may result in electrical shock or short, causing a spark.

◆ Always use the power supply indicated in the machine plate.

If the operating voltage is higher than indicated, the motor will run at abnormally high speed, 
which may damage the machine. 
If use the machine at over voltage indicated in the machine plate or instruction manual, the 
machine may become hot, emit smoke or catch fire.

◆ Make sure that the switch is off before plugging the machine in.

Pull the Trigger Switch to turn on and release to turn off. Always make sure that the 
Trigger Switch returns when you release the trigger pulled. 
If you insert the plug into the receptacle, not knowing the switch is on, the machine will start 
abruptly, leading to an unexpected accident.

◆ In case to use engine generator, use the engine generator which output 

capacity is more than 2.8KVA with inverter control type.

If use engine generator without inverter control, the machine will be broken.

Fixing the vise

◆ Vise and main body stained with cutting oil is slippery. 

Wipe off the oil completely. 

Do not drop the machine on your feet when lifting it．

◆ When installing the machine, check the supporting force of the pipe(existing pipes). 

Do not install the machine to the decrepit pipe．

◆ As this machine is heavy, carefully lift when 

installing it in the high position．

◆ Do not install the vise on the "cutting off side."  

The cut pipe together with the vise will drop. 

This is very dangerous.

◆ Fix the vise firmly.  

If the vise fixing force is weak, the main body may drop or the 
saw blade may be broken while cutting.

◆ Watch the position of your finger while lowering 

the vise to avoid pinching of fingers.

WARNING

WARNING