Asada 380SP, Instruction Manual

PIPE SAW 380SP

13

How to set the main body

How to set the Saw Blade

① Disconnect the power plug．

② Check that there is no foreign matter in the rotary 

shaft of the main body and the rotary bush of the 
vise. Remove the foreign matter, if any.

③ Firmly holding the main body grip and motor grip 

with both hands, mount the main body to the vise．

  Insert the rotary shaft of the main body into the 

rotary bush of the vise with adjusting mutual 
square spline to arbitrary angle and insert the main 
body up to the full end.

① Select the saw blade conforming to the size 

and material of the pipe to be cut.

② Insert the saw blade between the "blade 

holder" and "blade guide," and hook it on the 
"saw blade fixing bolt" and "mounting pin."（Pay 
attention to direction of saw blade.）

③ Clamp the "saw blade fixing bolt "(with flat 

washer）with the attached ratchet wrench.

◆ Use the saw blade of the size conforming to the pipe diameter． 

If the thick pipe exceeding the cutting capability of the blade, the tip of the saw blade touches 
the inside of pipe resulting in breaking of the saw blade.

◆ Do not use the damaged saw blade． 

As resistance of cutting face increases and load is applied, breakdown is caused.

◆ If clamping of the saw blade is weak, the saw blade may come off during 

cutting, and the main body and saw blade may be damaged．

Insert

Rotary bush

Rotary shaft 

Square spline

Blade holder

Mounting pin

Blade guide

Blade

Pay attention to direction

2

Saw blade fixing bolt

Clamp

3

CAUTION