PIPE SAW 380SP
21
TROUBLESHOOTING
● Before asking for repairs, check following troubleshooting.
If the problem cannot be solved, contact with the shop you purchased or our sales office.
● Troubles due to misuse or improper applications are not covered by warranty.
Phenomenon
Cause
Measures
Power Issue /
Machine not
working
Damaged Power Cord
Replace the power cord if damages are found.
Low voltage
When the extension cord is too long or too thin, see
"Extension Cord" on P10 and use a proper extension cord.
Working Over-load
Protector
Make sure that the motor is cooled down enough, and
then turn on the switch again.
Insufficient
power
Low voltage
When the extension cord is too long or too thin, see
"Extension Cord" on P10 and use a proper extension cord.
The Saw Blade
is broken, and
/ or is loose
Loosed Clamp Bolt of
Blade Holder
Re-tighten Clamp Bolt.
Forcing the machine
to cut
Do not cut by force. Cut slower.
Unfixed Chain Vise
Fix the Chain Vise to the work piece firmly.
The machine
stops during
cutting
Low voltage
When the extension cord is too long or too thin, see
"Extension Cord" on P10 and use a proper extension cord.
Working Over-load
Protector
Make sure that the motor is cooled down enough, and then
turn on the switch again. Do not cut by force. Cut slower.
Worn out Carbon
Brushes
If Carbon Brushes are worn down to around 6㎜, they
must be changed.
Worn out saw blade
If the saw blade is worn out, cannot cut properly.
Change the saw blade to new one.
Oblique
cutting
Worn out saw blade
If the saw blade is worn out, it causes of oblique
cutting. Change the saw blade to new one when it's
worn out.
Jammed
contaminations
between Chain Vise
and the work piece
Remove the contamination jammed between Chain Vise
and the work piece.
Forcing the machine
to cut
Do not cut by force. Cut slower.
Summary of Contents for 380SP
Page 23: ...PIPE SAW 380SP 22 ...
