Alle rechten voorbehouden.
Niets uit deze uitgave mag worden verveelvoudigd, opgeslagen in een database of openbaar gemaakt, in enige vorm of op enige wijze, hetzij elektronisch,
mechanisch, opnamen, of enig andere manier, zonder voorafgaande toestemming van ASCGroup.
8
2.2
Personal protective equipment
Always wear work gloves, safety shoes and safety helmet.
2.3
Assembly
Aluminum roof edge protection devices may only be constructed by competent persons. According
to regulations, each person assembling the roof edge protection must be secured with a fall arrest
line.
For checking for damage: see chapter 3.
No tools are required when assembling a roof edge protection. Roof edge protection devices are
not designed to be lifted or hung as a whole.
2.4
Assembly Instructions
1.
Prepare the gutter post for use (see picture on the right).
2.
Pull out the locking bolt and slide the clamp cap up about 7.5 cm.
3.
Measure the width of the gutter.
4.
The distance between the post and the slide bar is approximately the width of
the gutter.
5.
Slide the lower stabilizer all the way back until the wall plate falls against the
slide rod.
6.
Prepare the net frame for use (see picture on the left)
7.
Slide the two tubes into the net with the coupling pins
to 1 side. Make sure there is a piece of tube left at
both ends.
8.
Slide the net frames over the tubes on both sides and
secure with 4 locking clips.
9.
Place the gutter post in the gutter with the base
placed as close to the roof as possible.
Using the component list, check that all the parts required for the required for
the assembly are present and undamaged. Damaged parts may not be used.
