Case Mounting
Note: This describes the optional case available with the kit.
The case is provided with all necessary cutouts and labels.
1. Put the extension caps on the tact switches.
2. Join the front panel and the PCB and insert both in the
respective brackets. The PCB fits in the brackets behind
the front panel.
3. Install and
lightly
tighten the lock nut of the BNC
connector.
The lock nut of the BNC connector must be mounted in
the orientation shown below, or it will prevent the case
from closing properly.
23
Summary of Contents for AE20401
