IMP/REV
active in mode: RPM
This adjustment allows selecting the number of pulses per one
revolution, it is then used to calculate RPM. With this, the rpm
output of rotary encoders/sensors that outputs multiple pulses
per revolution can be measured.
D
(ecimal)
Point ["." / ","]
active in mode: all
The number format (decimal point and thousands separator)
can be selected between the format: "123.123.123,123 Hz" or
"123,123,123.123 Hz" to match the use of different symbols
worldwide.
Note: this adjustment is accessible from all channel's menus, but the same
value is stored for all channels. The PC software also uses the selected
format for its display.
T
(ime)
base
CAL
(ibration)
Starts the calibration routine for the time base. See the
appropriate chapter on how to perform the calibration.
Note: the same routine is used for channels A and B, as they share the same
time base.
34
Summary of Contents for AE20401
