Menu Functions
EXT
(ernal)
ATT
(enuator)
[on/off]
Set this to on, if an external attenuator is connected, and enter
its value in the next menu item. This value will then be added
to the measurement. A small
A
T
indicates that this function is
on.
EXT ATT [VALUE]
The value of the external attenuator can be entered here in dB.
FREQ
(uency)
[1/100/200/300/400/500 MHz]
(AE204015)
FREQ
(uency)
[10 MHz/1/2/3/4/5/6/7/8 GHz]
(AE204014)
The logarithmic amplifiers which are used in this modules has
a slight frequency dependence. A correction factor that
compensates for the frequency error can be applied to the
measurement by entering the frequency here (in 100 MHz / 1
GHz steps).
Note: these correction factors can be adjusted by performing the full
calibration procedure for the Power Meter - see the appropriate chapter
about the calibration.
39
Summary of Contents for AE20401
