and press
Menu/OK
. During calibration,
"CALIBRATION..."
is
shown. Next,
"CONNECT xx dBm"
is shown, change the signal to
1 MHz, +10 dBm (AE204015) or 10 MHz, -10 dBm
(AE204014). If no valid signal was recognized or the signal is
outside of the max limits for calibration,
"CAL ERROR, VALUE
NOT SAVED!"
will be shown, otherwise
"CALIBRATION DONE
VALUES SAVED"
. Press
Menu/OK
to advance to the next part.
Now you will be required to connect a number of specific
signals:
"CONNECT xx dBm yy MHz".
Set the required values and
press
Menu/OK
to advance each time. A successful calibration or
an error will be shown again after the calibration is finished.
Press
Menu/OK
one last time to leave the calibration routine.
42
Summary of Contents for AE20401
