Product Manual
SECTION 5
VIRTUOSO 5460F
115057 REV L
42
5.3 Testing the Relay Module
The relay module (Smarty Relay) is located on the control panel. See Section 4.6.
A green light on the relay module indicates that it is receiving power and is ready for
use. Note that the relay module requires 6-8 seconds to initialize after it receives
power, during which time the relay light is red. Always give the module time to initialize
before performing any testing on it.
To test the function of the relay module, refer to the logic diagram on page 38.
If the relay module is not receiving power, check for and correct the following conditions
as necessary:
1. AC supply to the lift has been shut off.
2. The power supply is not supplying 12 VDC. Refer to Section 5.4 to check it.
3. There has been a wiring harness or connector failure. See the Electrical Diagram on
page 38 or the detailed electrical schematic that was included with the lift to continue
troubleshooting.
4. The E-Stop is pushed in and the alarm is active. Press the E-Stop to deactivate
alarm. Relay will restart in 6-8 seconds.
Summary of Contents for VIRTUOSO 5460F
